Complete metal roof panel production line

Complete production line of widened metal roof panel

Technical parameter model:21-215-860

Length×width×height 5000mm×1300mm×1200mm

Total weight:about 2.1 tons

Forming shaft:diameter 68mm,45×quenching and tempering

Forming wheel:material 45×forging hard chromium plating

Transmission mode:sprocket,chain

Complete set of metal roof panel production line motor:3kw

Metal roof panel complete production line forming row number:10 rows

Motor of pump station:3kw,four stages

Cutting die:Gr12

Molding speed:8-10m/min

Pressing thickness:0.2-0.7mm

Pressing width:1000M

The straightening of bending or twisting of tile press equipment is usually carried out between the latter forming roll and the cutting die.If the latter roll can not support the profile,the whole profile section will be supported when it enters the side of straightening mechanism.For asymmetric straightening,torsional deformation may occur at the same time of straightening.At this time,it needs to be straightened in the opposite direction of profile deformation Straighten by bending and torsion.

When straightening the profile of tile press equipment,it is not necessary to contact with the profile surface and straightening mechanism.However,the contact with straightening mechanism is very important at and around the bending deformation of profile.In order to avoid profile deformation,the arc radius of straightening mechanism contour should match the arc of profile section.